Red Hood Rebirth Helmet

in Work In Progress WIP

Here is the helmet fresh off the printer.

Printer used. CR 10 V2

Filament used FilaCube

Cura settings

Layer height .2

Infill 20

Printing temp 220

Bed temp 60

Print Speed 80

Supports Everywhere

Adhesion Raft

Print time 23 Hours and 13minutes

11 comments

11 Comments

eLux

Sep 10

Finished printing it a few days ago and halfway sanding. Have you updated the model to allow the attaching of magnets? I'm asking because the backplate want to slide through. I have an idea of how I would do the magnets (would need to create some glue on magnet holders, but just curious if you have already done that.

jorden23

Sep 12

Replying to

You might want to message @Do3D Admin about that. I used elastic to attach the backplate.

eLux

Sep 13

Replying to

Thanks. I ended up designing some magnet holders for the side by the ears and will probably use elastic strap at the top. But may try some magents as well to see how it holds.

Gerran Mora

Feb 22, 2022

just put in the settings and the position but used .28 and I got 2 days 3 hours in cura ..wtf.lol

jorden23

Feb 22, 2022

Replying to

Can you share a screen shot of your settings?

alanmilin922

Oct 29, 2021

having some issues with this model, i printed the front and back pieces at 100% scale, but it seems like no matter how i print it, the back plate doesn't match with the front. as if its wider and has a different curve.