Dear All,
Would like to share what 3D printer, filament, hardware, software and other tools i have been using for my 3D printing projects.
3D Printer: Anycubic 4Max & Trinus
Filament: Any cheap filament no particular brands
Hardware: Several Hardware as shown below
Extra fan for positive flow of air going outside (keeping room air clean)
LED light to light up the case for both my printers
Xiaomi camera to monitor prints anywhere i go
Spool holder to allow smooth feed of filament for both printer
Filament dryer to keep filament at the best condition to print (dry)
Pliers to snip of filament or that is left on the 3D parts
Sand paper to clean the surface smooth (getting a orbit sander soon)
3D pen is for me to join 3D parts together. (i think is a good idea i thought myself)
Neodymium Magnets are great to create detachable helmets (totally recommend this)
Software: Cura, Pango & Meshmixer
Cura - Slicer for Anycubic 4Max, i personally think it is a great software and best thing is free
Pango - Slicer for Trinus, simple and easy to start off with.
Mesh Mixer - To help me slice part into small piece to fit my printer
I bought my 3D printer only to do one thing is to print iron man.
only started off with few helmets and have not complete a full suit before.
My aim is to complete an entire suit that Do3D is about to release.
Please see my latest print below:
Would like to thank specially Frank Lee Pillar, answer to all my inquiries about 3D printing.
a very helpful chap., kudos to him. You all might want to visit his youtube channel to learn more:
https://www.youtube.com/channel/UCsnKS1fVNJ1yjCkGOXXDd4A
Quote of the day ! Failure is just a bend in the road, its not end of the road.
Finish what you started !!!
Thank You