Hi all, pretty new to the world of 3d printing, especially cosplay prints. It's quite a lot to take in: scaling with Armorsmith, cutting using Meshmixer and finally slicing using Cura. My printer is an Anycubic Mega i3, but with a few modifications (Noctua fans, TMC2209 stepper drivers and a Raspberry Pi case on the side). The printer is working great for me, but I would prefer a larger print volume though. The Ultrabase is great and sticky for PLA prints.

I mainly use ICE PLA and eSun PLA+ filament. All my current prints are "rough" and waiting for some good sanding action and finally paint. I am waiting for better weather since I tend to do that in the shed outside.
Currently there is a Bane mask on the printer, but the other pieces are for an Iron Man MK3 build. And yes, the printer room doubles as the LEGO room.
