hi all. purchased the mk3 files and have started looking into scaling to print helmet. but have notice the lower chin piece is not level, eg is slightly misaligned to the left. did o get a bad file or am i missing something? thanks
top of page
bottom of page
Check the original files: Make sure you have downloaded the files from a reputable source and that the files themselves are not corrupted or damaged.
Use a different slicer: If you are using the same slicer for all your 3D prints, try using a different slicer software to check if the misalignment issue persists. Sometimes, using an alternative slicer can yield different results. Dave The Diver
멋진 카지노 서비스로 환상적인 경험을 다파벳 했습니다. 게임은 즐거웠고 많은 돈을 얻었습니다. 고객 서비스는 친절하고 도움이 되었습니다. 그들은 내 질문에 신속하게 응답하고 내 모든 질문에 답변했습니다. 지불금은 빨랐고 상금은 신속하게 처리되었습니다.
Hi, we already sent the new helmet file to your email previously but wanted to post here as well so that others get to know how the Iron Man Mark III helmet has been updated. Thank you.
There was already update on the mk 3 https://www.do3d.com/forum/do3d-updates/iron-man-mark-iii-helmet-updates
Our support team will send you the new download link today. Thank you.